#Del sol hot tub owners manual manual#

You might try using this Owner's Manual to change the filtration settings and see if the issue goes away. Or, if for some reason you have power fluctuations such that the spa temporarily loses power, it'll probably reset to the factory default F1 setting each time (which also means it'll start the cycles over again). If your spa is set to the F1 filtration option, and is activating more than once every 12 hours, there may be an issue with it's controls/brain. It indicates this should run one 30-minute cycle every 12 hours. On page 29 it shows that ' F1' indicates the spa is running the factory default 1 hour filtration cycle.

Here's the owner's manual for the 2008 Chelsee model: Stay on top of hot tub maintenance by getting to know the manual and user guide for your spa. Now that you are in the know when it comes to error codes, you can relax and enjoy your hot tub safely. Your scalding hot tub will likely trigger the Watchdog software, which will deactivate the spa and flash red safety lights as a warning. Call a service tech right away and be sure to secure the cover on your hot tub so that no one else attempts to use it. This means that the water is dangerously hot. If you see dashes on your hot tub control panel, do not attempt to use your spa. If this does not restore the water to a safe temperature, secure the cover on the hot tub and call your tech. Program the filter for Economy mode, and cancel the Summer Logic condition, which occurs when the actual water temperature goes above the set temperature. You can call a tech for assistance, but here is a home remedy you might want to try first: Take the spa cover off and let the water cool down. The above error codes do not indicate immediate danger to the user, but the following codes do: The hot tub heater and jets pump will likely deactivate, so now is a great time to call a service tech.

#Del sol hot tub owners manual code#

This code means any of the following: the flow switch is malfunctioning open (FL1) or closed (FL2), the filter cartridge needs to be changed or cleaned, or there is an РІР‚Сљair lockРІР‚Сњ condition at the circulation pump intake. It is not a good idea to use your hot tub when the sensors are malfunctioning, so call your friendly spa tech for assistance.Р”Р‡L1/FL2. This indicates that there is an open or shorted sensor, which means your heater is disabled and/or your hot tub has deactivated. You can purchase one from your local JacuzziР’В® dealer. If you see some variation of the letters BLB flashing across your control panel, it means that the UV bulb needs to be replaced. Eventually, the water will return to its normal winterized temperature.Р”В«lb/BLB.

Heater will activate, so no need to call a tech in for this, either. No need to call a tech-just let the heater do its job and the water will reach its set temperature. It pops up whenever there is a steep drop from the set temperature, such as when you fill/refill your spa. Hot Tub Lingo 101: Understanding Hot Tub Error CodesР”Вo you speak hot tub? While it is a good idea to keep your hot tub manual handy, here are a number of must-know error codes and their follow-up actions that will keep you and your fellow soakers safe.Р”В¬OL/COOL.